Filtered Contaminants: arsenic (pentavalent), cysts, fluoride, lead, TDS

Replacement Interval: 18 months

Temperature: 40°F - 100°F (4°C - 38°C)

Maximum Pressure: 80 PSI (552 kPa)

Minimum Pressure: 40 PSI (275 kPa)

TDS: <2000 mg/L

Chlorine: <1.0 mg/L

Turbidity: <1 NTU

SDI: <5

pH: 4-8

System Production: 14.61 GPD

Recovery: 26.76%

TDS Rejection: 96.5%

Compliance: NSF/ANSI 58

Filter Components: 20 micron sediment prefilter, granular activated carbon (GAC) prefilter, reverse osmosis membrane, granular activated carbon postfilter

INSTALLATION

Install the cartridge by aligning it with the connectors, pushing firmly until seated, and securing the retaining clip fully in place. Ensure both feed valve and tank valve are closed before installation, and check for leaks after restoring water flow. Do not use with water that is microbiologically unsafe without adequate disinfection.

MAINTENANCE

Replace cartridge every 18 months under normal usage conditions. Close feed and tank valves, relieve pressure through the dispensing faucet, then remove and replace the cartridge ensuring the retaining clip is properly secured. Flush system for 5 minutes after installation.

PROFESSIONAL ASSISTANCE

Contact a qualified professional if you experience difficulties during installation or maintenance, notice persistent leaks, or if your system is installed in a hard-to-access location. Professional installation is recommended for initial system setup to ensure proper function and avoid water damage from improper installation.

Performance Sheet

Warranty