Experience greater benefits by purchasing direct on PlumbersParadise.net
Everpure EZ-RO 375/10G (EV997557) Reverse Osmosis System with 10-Gallon Tank
The Pentair Everpure EZ-RO 375/10G is a high-efficiency commercial reverse osmosis system that delivers up to 375 gallons per day of optimized water while reducing total dissolved solids, hardness, and chlorides to protect steam equipment, with a complete all-in-one design featuring a 10-gallon hydropneumatic storage tank, proprietary mineral addition technology, and space-saving installation options.
Performance & Specifications
| Feature | Specification |
|---|---|
| Model Number | EZ-RO 375/10G (EV997557) |
| Daily Production Rate | Up to 375 gallons per day (1,419 L/day) |
| Tank Capacity | 10 gallons (37.8 L) hydropneumatic |
| Water Recovery Rate | Up to 50% (2x more efficient than standard RO) |
| Contaminants Reduced | Total Dissolved Solids (TDS), hardness, chlorides, chlorine, sediment |
Key Features
- ✓ All-in-One System: Complete package with processor, filters, membrane, 10-gallon tank, and installation hardware included—no additional SKUs needed
- ✓ 4CM Mineral Addition Technology: Proprietary cartridge adds back optimal minerals for proper conductivity sensor function in steam equipment while maintaining equipment protection
- ✓ High Efficiency RO Membrane: Saves up to 2x more water than standard RO systems with up to 50% water recovery compared to traditional 25% recovery rates
- ✓ Fibredyne II Prefilter Media: Effectively inhibits bacterial growth on filter media while reducing sediment and chlorine to protect the RO membrane and extend system life
- ✓ Expandable Design: Compact 16.6" H x 17.4" W x 8" D processor accommodates larger capacity membranes and tank upgrades without replacing the main unit—wall mount, floor stand, or under-counter installation
- ✓ Built-In Service Features: Integrated bypass, sample port, flush valves, and pressure gauge speed up installation, maintenance, and monitoring of system performance
FAQ
Q: How long does it take to install the EZ-RO 375/10G system?
A: Once the installation area is prepared with proper water supply, drain access, and mounting location, the system can be installed in 45-60 minutes. This does not include the required cartridge flushing time—prefilter and mineral cartridges need about 5 minutes of flushing until water runs clear, and the RO membrane requires 1-24 hours of flushing per NSF standards.
Q: What feed water conditions are required for the EZ-RO 375/10G to operate properly?
A: The system requires cold water (40-100°F) with 50-100 psi pressure, TDS up to 1,000 ppm, hardness ≤12 grains per gallon, free chlorine <3 mg/L, pH 5-10, and specific limits on iron, manganese, silica, and other contaminants. Operating outside these parameters may cause premature membrane failure and void the warranty. A water analysis should be conducted before installation.
Q: How often do the replacement cartridges need to be changed on this system?
A: The 4FC5-S prefilter cartridge should be replaced every 6 months, the 4CM mineral addition cartridge every 12 months or as needed, and the EZ-375 RO membrane cartridge every 18-24 months. Replacement frequency depends on water quality, usage volume, and maintaining proper feed water specifications.
What's Included
- EZ-RO processor unit with built-in bypass, flush valves, and pressure gauge
- 10-gallon hydropneumatic storage tank with pre-installed valve
- 4FC5-S prefilter cartridge (EV9693-31)
- EZ-375 reverse osmosis membrane cartridge (EV9628-93)
- 4CM mineral addition cartridge (EV9627-80)
- Complete installation kit with tubing (1/4", 3/8", 1/2"), push-to-connect fittings, and mounting hardware
- Installation and operation guide
Note: Only use this system with water that is known to be safe. If the water quality is uncertain, ensure it is disinfected before or after filtration.